How to lower your SDG&E bill as a small business

Start by reading your bill and checking your rate plan, then cut after-hours waste and move flexible loads out of the 4 to 9 p.m. peak. Bigger upgrades come after the cheap fixes.

By the San Diego Green Chamber · Updated November 2026

Cafe owner and contractor reviewing an energy bill at the counter

To lower your SDG&E bill as a small business, start with three no-cost steps: understand what you are actually charged for, confirm you are on the best rate plan for how you use power, and stop paying for equipment that runs when nobody is there. Then move flexible loads out of the 4 p.m. to 9 p.m. on-peak window on most time-of-use plans. Equipment upgrades such as LED lighting, HVAC improvements and solar come next, ranked by payback.

Read your bill like an accountant

A commercial bill has several parts, and each one responds to different fixes. Pull 12 months of bills from your SDG&E online account and look for:

  • Energy charges per kWh, which vary by time of day and season on time-of-use plans.
  • Demand charges, if your rate has them, based on your highest use in a short interval during the billing period.
  • Delivery and generation lines. If your city is served by a community choice aggregator, generation appears from that provider while SDG&E still delivers power and sends the bill.
  • Fixed or customer charges that do not change with use.
  • Gas charges, if you have gas service for heating, water heating or cooking.

Note which months are highest and whether the spikes come from energy use or demand. That tells you where to look first. A cafe whose bill jumps every August has a cooling problem. A shop whose demand charge stays high all year may have one large piece of equipment starting at the wrong time.

If you have gas service, apply the same review to the gas side. Water heating, space heating and commercial cooking are the usual drivers, and gas bills in San Diego tend to rise in winter. Tune-ups, pipe insulation, lower water heater setpoints where code allows and fixing pilot lights on idle equipment can trim that portion of the bill.

Check your rate plan

SDG&E offers several business rate plans, and the cheapest one depends on when and how you use power. SDG&E’s online account tools can compare plans using your actual interval data. Run that comparison at least once a year and after any big change, such as adding EV chargers, solar or new equipment. A business that runs mostly in the morning has different needs from a restaurant that peaks at dinner.

Many San Diego County cities are now served by San Diego Community Power or Clean Energy Alliance for electricity generation. Their rates and plan options differ from SDG&E’s, so check both when you compare costs.

Cut waste you are paying for

The fastest savings usually come from equipment running when it does not need to. Walk the building after closing and write down everything still on. Common finds:

  1. HVAC running on a schedule that no longer matches your hours, or thermostats overridden and never reset.
  2. Lights left on in storage rooms, restrooms and back offices.
  3. Water heaters, display cases and coffee equipment running all night.
  4. Computers, monitors and printers that never sleep.
  5. Exterior and sign lighting on timers that drifted out of sync with sunset.
  6. Refrigeration with dirty coils or worn door gaskets, which forces compressors to work harder.

Fixing these costs little: programmable thermostats, timers, occupancy sensors, a maintenance visit and a closing checklist for staff. Compare the next few bills to the same months last year to confirm the savings. Assign one person to own the closing checklist. Savings fade quickly when nobody is responsible for them.

Shift load out of peak hours

On most current SDG&E time-of-use plans, the on-peak window runs from 4 p.m. to 9 p.m. every day, and summer peak prices are the highest of the year. Check your own rate schedule for the exact periods. Moving flexible loads earlier in the day or overnight can lower costs without using less energy. Pre-cool the building before 4 p.m., schedule dishwashing, laundry and EV charging outside the peak, and run pool pumps or process equipment earlier. Our guide to shifting load on time-of-use rates goes deeper.

If your rate has demand charges, avoid starting several large loads at once. Staggering equipment start-up in the morning can cut your peak demand reading for the month.

Then invest in upgrades

Once the free fixes are in place, rank equipment upgrades by payback:

  • LED lighting and controls, often the quickest payback for older fluorescent or metal halide fixtures.
  • HVAC tune-ups and replacements, especially rooftop units near end of life.
  • Refrigeration upgrades for restaurants and grocers, such as efficient motors, door closers and controls.
  • Solar and battery storage, which can offset daytime use and cover part of the evening peak.
  • An energy audit, if you are not sure where to start or your building is complex.

Before you buy, check SDG&E’s current business programs and any incentives available through your community choice provider. Program offerings change, so confirm terms directly. Efficiency contractors in our energy efficiency and HVAC network can help you prioritize.

How chamber membership helps

Every San Diego Green Chamber member commits to reducing energy and water use, and a lower bill is the most direct proof of that progress. Members get education on rates and programs, a Member Business Directory listing to find efficiency contractors and solar installers, and free networking events co-hosted with San Diego Green Drinks, where business owners compare what actually worked. See how membership works.

Questions

What are SDG&E’s peak hours for businesses?

On most current time-of-use plans, on-peak hours run from 4 p.m. to 9 p.m. every day. Check your own rate schedule on your bill or SDG&E account for the exact periods.

Can I switch my business to a cheaper SDG&E rate plan?

Often, yes. SDG&E’s online tools can compare plans based on your actual usage. Run the comparison and confirm eligibility before switching.

Does a community choice provider replace SDG&E?

No. San Diego Community Power and Clean Energy Alliance supply electricity generation in the cities they serve, while SDG&E still delivers the power, maintains the lines and sends the bill.

Prove it. Get referred for it.

Join the San Diego Green Chamber to get listed, introduced and referred by businesses that check.

Join the Chamber Find a Business